DELL POWEREDGE EXPANDABLE RAID CONTROLLER 3 DI DRIVER
Array Manager obtains data from storage devices and the logical volumes contained on those devices. The current ones are backward compatible, however, so all that is necessary is to create some symlinks: If you are adding a version 2. The following procedure was done on Centos 5 but with little tweaking should work on almost any Linux distro. The physical view shows the physical connections between the storage devices. Once the agent is running properly, the next big task is to determine what to monitor.
|Date Added:||5 February 2010|
|File Size:||38.25 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
For information on how to perform the upgrade, see Performing an Upgrade Installation. Warnings alert you to actions that might cause injury to you or someone else. This page was last edited on 2 Augustat The current ones are backward compatible, however, so all that is necessary is to create some symlinks:.
Introduction: Dell PowerEdge Expandable RAID Controller 3/Di INSTALLATION GUIDE
Views Read View source View history. Array Manager obtains data from storage devices and the logical volumes contained on those devices. The following procedure was done on Centos 5 but with raaid tweaking should work on almost any Linux distro. Retrieved from ” https: Now this software has not been changed in quite a few years, so some tricks are needed to get it to install and run.
Dell PowerEdge Expandable RAID Controller 3/Di INSTALLATION GUIDE
Cautions alert you to actions that might cause damage to your system or your data. Dell does not claim to have included in this document every condition or situation that might require a caution or warning notice.
The logical view shows a logical representation of your storage as logical volumes. FAST can create a container consisting of partitions on different disks where each partition is less than the entire disk’s capacity.
Monitoring a Dell PowerEdge Expandable RAID Controller 3/Di
Remember to define the class at the bottom of that file: The first thing that is needed is the afa-linux-app-A These instructions have been borrowed from a post concerning setting this up for Nagios. According to the MIB the values mean:. The next step is to create an “adasnmpd. Untar the file and install the RPM: OpenNMS can theoretically monitor anything whose status can be retrieved over the network. For more information, see Installing the Controller Management Software.
Start the two agents: This configuration says to walk all of the values starting at. The final step is to modify poller-configuration. For more information, see Installing the Device Driver.
OpenNMS will use this to check the status of the attached drives. Be sure to consult the documentation for your computer and any connected equipment when you are installing the equipment or changing its configuration.
This will stream a large amount of information. Notes are reminders, tips, or suggestions that might simplify the procedures included in this document.
Always use caution when handling electrical equipment! Enter Used for key names, screen elements, and for options you are told to select. To avoid injury to people or damage to equipment and data, be sure to follow the cautions and warnings in this document. If you are adding controlelr version 2. The current ones are backward compatible, however, expandaable all that is necessary is to create some symlinks: You have to use “–nodeps” since the libssl and libcrypto versions that the original code was compiled against are very old.